44104 Grip 4000KG FULLY WELDED HYDRAULIC BOTTLE JACK

 APPLICATION 

  • Bottle style hydraulic jack for the lifting of vehicles or other heavy components and/or equipment so that maintenance can be performed 

 

FEATURES 

  • Heavy duty steel construction, fully seam welded base and top cap for superior leak resistance 
  • Fully machined steel (not cast iron) heavy duty base plate 
  • Quality chrome hydraulic ram and piston pump 
  • Black baked enamel finish for corrosion resistance 
  • Australian Standard compliance 

 

SAFETY NOTICE 

  • The jack should be used on hard, level surfaces 
  • The wheels of the vehicle to be chocked 
  • Do NOT put a portion of your body under a vehicle supported by a jack 
  • No person should remain in a vehicle that is being jacked 
  • Do NOT exceed working load limit 

Specifications:

SPECIFICATIONS 

  • Working load limit: 4000kg
  • Minimum height: 212mm
  • Maximum height: 407mm
  • Hydraulic lift height : 118mm
  • Screw height adjustment: 70mm
  • Base plate dimensions: 120(L) x 110(W) x 170(H)mm
  • Australian Standard: AS/NZS 2693 : 2007

 

Please note: Vertical lifts only, if jack is tilted to any angle other than vertical position from base plate the hydraulic system will not operate. 

 

MAINTENANCE NOTE 

  • It is recommended that the oil level should be approximately 3mm below the oil filler hole 
  • To add oil lower the jack to the lowest position, then remove the air vent valve, add oil to desired level, pump jack 5 or 6 times to expel any air in the cylinder, and then fasten the air vent valve.  Use only ISO10-S hydraulic fluid .DO NOT USE BRAKE FLUID, ALCOHOL, GLYCERINE , DETERGENT, MOTOR OIL OR DIRTY OIL.



   Pin it